Head Meatotomy to Allow a Prince Wand Inserion

My desire to explore the pleasures of a Prince Wand was sparked one day in 1993 when I came upon one in the display case at Body Modifications here in San Francisco. I promply ordered a 10 millimeter version from England. When it arrived I found that it was too large to insert, although I could take a 9 mm sound. I ordered an 8 mm version and when it arrived I found it to be quite uncomfortable to wear for more than a few hours, and when worn overnight there would be a bit of bruising around the urethra opening. I presumed this was due to the weight of the steel wand and the angle of the PA stud putting pressure on my 5mm PA hole. I searched the net in early 1996 and found that Stainless Studios in Toronto could manufacture for me a 9mm custom titanium prince wand.

The day it arrived I found it took me 3 hours of pushing to insert it completely. The grooves cut into the body were excruciatingly wonderful. When I achieved complete insertion I was so happy that I pushed it in over the edge and with a popping sound the 3 inch wand disappeared entirely into my 5 inch raging erection. This is when I realized that the tip of my urethra was much tighter that the rest of the length of it. I also immediately realized that extraction was going to be a problem, as I could grab the wand by threading the stud into the end of it and try as I might , I could not overcome the enormous pressure exerted by the urethra opening. However I was free to pump and rotate the wand freely deep inside the urethra. When my erection finally subsided after many hours I would sometimes find the wand had slipped down into my sac. A couple of shakes to stir an erection and the wand would come popping back up the shaft. I had no idea how to get the wand out but some how I knew that it would come out on its own. Sure enough 3 days later after a swim in the cold ocean and a hot shower I was putting on my boots and the 3 inch metal chunk popped out of my cock. Much happiness and relief for me and I realized that any pain caused by the wand was entirely due to pressure on that tight Urethral Sphincter.

I knew I had to do a meatotomy but I had no idea what to do. Should I use cuticle nippers or cuticle scissors or x-acto knife? Should I make gradual cuts or one long and swift cut? Glider suggested using scissors. Gathering Revlon Cuticle Scissors and Betadine Iodine Ointment, I waited for the right moment to proceed. Stroking and teasing the web of flesh at the bottom of my urethra with the scissors, I sought the strength to enlarge my hole. After an hour of fearful prodding and poking I made the first tiny cut almost by accident. I was amazed watching the flesh seperate and hearing the sound of the scissors slicing my body. My fear melted into erotic stimulation and my next tiny cut was into a rock-hard cock and a couple of drops of blood was not the only fluid dripping from the end of it! This was the first of many very stimulating and addictive cutting sessions I have performed on my urethra tip and here is what I have learned:

Questions?
Comments?
Mailme at mofo@thepentagon.com

cheers maRk LsHarK


Return to male piercing