At A Glance Author anonymous Contact anonymous@bme.anon When Six months ago Artist myself Studio bathroom Location asia It was one fine day that I came across a club with piercing at the yahoo site which eventually led me to this site. Wahhhhhhh, to my surprise and excitement, I went through what it had to offer. Ideas started to come into my mind. I felt a stream of excitement that flowed through my body. What a feeling to have mine pierced. I started to look up for studio that could do that. But to my dissatisfaction, there was none around. After a long search in the web, I found there was a studio but I had to travel that long distance and furthermore by plane. Ohhhhhhhhhh, it was going to be an experience piercing. I did ring up the piercer and the cost for a PA was rather high. He only did a normal PA not a reverse. Well, I was very much inclined to male a trip to do that. I planned for a trip and rang him up again, too bad during that period, he would be out of town. What a timing!!!!!!!!!!!
This gave me more time to read up your web site and got the idea of self piercing. I then looked up for the site to purchase the required items. I did go to a pharmacy store to get the biggest hypo needle. I was so excited and wanted just to try it out. But there was no suitable jewelry etc. To satisfy my ego, I tried out with the needle and with a cooper wire. I prepared all the required items, lined them up properly after boiling them in water for twenty minutes. Positioned myself over the toilet seat with the cover down, with the needle in my hand, I tried to position the needle into the receiving tube. I guessed that the needle must had touched the skin without my knowledge and blood started to ozze out like having a abortion. This really panicked me and caused me to withdraw the needle and give a hard compression. Luckily, the bleeding stopped after a few minutes. Then I started again, gee, my hands were shaking and it was hard to control. With determination, I gave a q uick and hard push and the needle went through with the count to 3, I held my breath and well, it was not that painful. Then what to do next?????, how to get the wire through, I started to figure what to do next. I pulled out the needle and try to insert the wire but the blood covered the hole and I could not find where to insert. Wah, what to do. In my mind I knew it was a failure. So, I abandoned the whole procedure.
Another session with the website search. I read more and tried to go through the one with self piercing. Well, some guys really gave very good account as to how to do it. Getting enough information, I then found a good time to do it, i.e. early in the morning while everyone was still sound asleep. Friday was a good one. I woke up early, eager to get it done and be proud with it as claimed by many. I had prepared all the necessary items even the night before. I gave myself a nice bath and sat over the toilet bowl seat. When through what had to be done as far as insertion of the needle, this time, it was fairly nicely done as I had gone through before and knowing what to do. Then I had the copper wire and pushed it through together against the end of the needle. Yes, it went through nicely. Then what should I do with the end of the wire??????. I then thought it would be all right just to twist the end up. So I did that, but it looked awful. Thinking that was the best for the time being, I warped it round with tissue paper. Looking at it, I was proud with it, but was thinking how long could I put up with it. I would not be able to have sex with my wife like that?????. I was hoping that my order could arrive the every day. Each day after this, I just had that wish, the order would arrive today. But this did not happen until the 4th day. So the curve banana bar came in and I was very eager to change it. That very night while everyone had gone to sleep, I went into the toilet and took off the wire first. As soon as I took off the wire I tried to push in the bar, damn it, it refused to go through. I pushed harder, ohhhhh, it was painful and blood started to ozze out. I did not want to force further and abandon the whole process. Well, I was thinking it would be easier to have it done by a professional. Anyway, I went to sleep and the next morning, to my surprise, I could not find the hole. It sealed up nicely, even though, there was a little pain st ill.
I waited for another week before I tried to pierced myself again. This time, it went smoothly. Now I have a PA with 10ga only one gauge up. I am very careful with it.