Not Once But Twice

At A Glance Author anonymous Contact anonymous@bme.anon Artist self Studio home Location Australia

NOT ONCE BUT TWICE

The idea of having different parts of one's body pierced never appeal to me , but the more I started looking and thinking about it , the more I was starting to enjoy the idea.

As time went on and I knew I was going to get myself pierced , I encounted the problem, that in the area where I lived, no one did full body piercing . This led me to decide that I was going to do the Prince Albert myself . My lack of experience seem to add an extra trill as I worked out how it could be done and was I able to go

through with it if the pain was too intense.

For the piercing itself , I brought a sewing machine needle because it had a wedge shape to it, which would allow easy penetration through the skin and enlarge the hole on its exit. Silver sleepers were then purchased for the jewelry as I heard that these did not react and cause infection to the wound.

Finally I decided on the big day and organized everything in the bath room so that if there was any bleeding , it could easy be cleaned up. By now I was both very nervous and excited as I positioned myself in the bath tub, ready to proceed with the needle. I picked it up and slowly started to positioned it down the eye of my penis , at this stage I was starting to shake. There was no stopping now and with the needle down the eye I worked out how far in it was so it would exit just below the head.

This was it , with a quick push the needle went straight through. What a rush to see the needle sticking out the bottom of your penis and eye at the same time. This was painless or the excitement took over and now I had to pull the needle right through. The other end of the needle that still had to go through was at least twice the size as the sharp end. This needed a firm grip of the needle as it did not move easy as it was enlarging the hole because of it's wedge shape. This took several minutes maybe longer until finally it had gone right through. As the needle exit from it hole,

blood started flowing which turned out to be the right thing being in the bath tub. As the blood flowed out the eye and open wound on the shaft I reached for the sleeper,opening it up ready for insertion. With the open end of the sleeper I placed it at the entrance of the wound on the shaft where the blood was still flowing and started to

feed it through. This was not easy as it appeared to get stuck while pushing it in .

At this stage the excitement or adrenaline was still running high , so I keep moving the sleeper into different angles hoping it would follow the exact needle hole that was created for it. while doing this, I guess it was helping to keep the hole open as the bleeding was not letting up. But at the last minute the sleeper went in and suddenly it appeared out of the eye where I matched the two ends up and the Prince Albert had taken it's prisoner.

The bleeding took another five minutes to stop, which added to the enjoyment which was far greater than any pain. I cleaned up an bathed the wound daily with saltwater and after several months of healing , I needed to improve my little Princr Albert into a larger one.

Again with no experience and with the Prince Albert healed up I tried to insert a larger ring ,but was unable to. Thinking about it , I got the idea to make a larger more permanent hole, now I was hooked. What I came up with was to use a small hand held leather punch that would enlarge the old hole by cutting the skin away rather than stretching it.

I went ahead and brought a leather punch with various sizes and chose the one that would make a hole about 2.5mm in diameter and a ring to fill the new hole. Again I set up in the bathroom, removing the sleeper, and using the old Prince Albert hole for a guild. I obtained a small length of wire that would go through the center of the punch, (this was to be used also as a guild) and inserted it up through the PA hole out of the eye. This was then feed through the center of the punch, which allowed it to travel drown the eye and line up with the old hole.

This was it, the bottom base of the punch was on my penis shaft waiting to meet up with the other half of the punch inserted in the eye.. I held the handles of the punch firmly, at which stage I could feel it starting to cut, causing me to feel uneasy and nervous all over again.

Thinking for a moment about my first Prince Albert , I soon realized this had come too far and with out thinking, squeezed the handles, holding them together. Wow! I had done it and now all I needed to do was to release the punch and insert the ring. This method causes a lot of bleeding as the large hole takes some time to gel. Any way the large ring was easier to insert than the original sleeper and once inserted help to stem the flow of blood. This took considerably longer to heal than the original, but in the end, for me ,worth all the effort. While having no great knowledge or experience about body piercing the above worked fine for me. This was only because I had no one available that did this kind of piercing. Since then I have located a good piercer who has given me a wonderful ampallang, but thats another story.