I am a 48-year-old uncut professional living in the UK. I have been fascinated with body piercing since coming across BME during researching my wife's interest in a navel ring after achieving Weight Watcher gold status. Alas she changed her mind.
At A Glance Author anonymous Contact anonymous@bme.anon Artist self Studio home Location wales UK I started with a DIY Prince Albert but that is another tale to tell. This I had managed to stretch up to 8mm but my urethra opening had enlarged during the stretching process and I was left with a very short piece of flesh supporting the ring only 7mm to 8mm wide. My wife never liked the PA and I normally removed it for penetrative sex. I had a small 5mm screw in ball ring that I was allowed to keep in on a couple of occasions but my wife claimed not enhanced sensations. I planned a DIY apadravya to be performed when my wife went on a week's holiday with a group of girls. I purchased a 2.6mm intravenous canula needle, a 2.4mm taper, two barbells and two CBRs in 2.4mm together with a 3.2mm taper and two 3.2mm barbells, one long enough to go through the PA and one to be used like an RPA with the ball inside my urethra, remember my PA is at least 8mm. My wife left for Portugal, my 17-year-old son had gone to bed and I was ready.
I decided to perform the procedure whilst sitting on a bidet. I put on latex gloves, placed a table with all the tapers and barbells on and psyched myself up to start. I had been reading Todd Bertrangs web site and decided to use a very tight elastic band around my penis to reduce blood flow. I marked the exit point as far back as I dared, to avoid the problem that I had had with my PA on stretching and provide the maximum amount of flesh between my urethra and the pierce. I opened the needle which came complete with syringe withdrew the needle into the cannula. I lubricated the out side with KY jelly, turned my penis through 90 degrees so that I could see what I was doing and inserted the cannula centrally and low down on the PA hole and took two deep breaths. I almost backed out and removed the needle. More deep breathing and summoning up my courage. I pressed the needle against my urethra wall and pressed a sharp pain and I increased the pressure. I could see the needle raise a lump at the marked spot and then saw the metal appear through my cock head. The amount of pressure was surprisingly large. I kept pushing and the cannula sheath slowly appeared. I pushed until there was no further progress and withdrew the needle that only had a spot of blood on it. I stood up and tried to calm myself and admired my new plastic addition to my genitals. The 2.4mm barbell was externally threaded and would not fit easily in the plastic tube; the taper, on the other hand, went over half way in. I decided to go with the taper. I lubed the taper and I placed the end of the barbell in the taper and pushed. It slid through quite easily until it came to the inner wall of my urethra when I had to push with some determination. The taper fell into the bidet, I had remembered to close the plughole, and screwed the 6mm ball in place. I had contemplated further tapering to 3.2mm but the pressure at my urethra wall persuaded me other wise. I slid my foreskin forward and admired the lump. I put on my briefs into which I had stuck one of my wife's sanitary towels and went to bed. In the morning there was no blood and the barbell felt really convertible. I decide that 3.2mm were for me. I put on new gloves and lubricated the tapers. I pushed the 2.6mm barbell out from underneath with the smaller taper and immediately pushed the 3.2mm taper into seal the hole. I place the larger barbell in the recessed end of the taper and pushed another sharp pain as the urethra wall was stretched and I now had 3.2mm of metal in my penis. On with my briefs and sanitary towel. I awoke several times that night with an erection; I was too excited to sleep. Next day, Sunday, I was in the office on my own, there was no pain and I could even tug gently on the ends to give a very pleasurable sensation, so much so that I came to a very gentle orgasm with just a little blood; over doing it I think! No bleeding on the Monday; On Tuesday evening I played cricket which was probably not very wise. Wednesday three was a swelling that made the barbell quite tight, sliding the lower ball into my urethra could relieve this, but this was not too practical with my foreskin. Lavender tea soaks seemed to help. The lymphatic secretions do not form crusties since they are kept moist by my foreskin. It is just over a week now and the swelling has gone down. My wife returns tomorrow, I hope she is not too grossed out by it since temporary removal for sex is not an option